h reset mode

[vovo]

hi sir:
i have jai-cvm10(rev D) progressive scan ccd but i can't use it in IMAQ 1409 because the exsample and document support (rev F) H non-reset mode,but my ccd jai-cvm10(rev D) is h reset mode,bye the way, if i want use the jai-cvm10(rev D H reset mode) with IMAQ 1409 how can i do, please give some suggestion.
thanks you a lot
vovo yang

[Kyle_V]

Vovo. Could you please ellaborate on the difference between the two modes? I take it that you need to run the camera in H reset mode, but that the 1409 works for the M10 in free run mode. Please give me some more info so I know where to start.

Kyle V

[vovo]

hi Kyle v:
thanks your answer,if i can change it to free run mode
i havn't the problem,so i get the document from NI about jai-cvm10 with IMAQ 1409 but it is support rev F only(h non-reset mode and h reset mode),my camera is jai-cvm10(rev D h reset mode only).
maybe,h reset mode and h non-reset mode are the singla
when restar, i am not undersatad too,web page is NI document below to :
http://zone.ni.com/devzone/conceptd.nsf/webmain/4F697CD5BCAA587D86256AB1006C3CC2?opendocument&node=1298_US
if you have any suggesttion tell me please.
my mail: mafardar@hotmail.com
thanks you help.
best regards
vovo yang