connect host pc running winXP to Stand-Alone cDAQ 9139 running win7 embedded via Daqmx

[MyKat]

Hi

trying to connect Stand-Alone cDAQ  9139 running embedded win7 to host PC running winXP via Daqmx 9.6 , both 9139 and host pc has Daqmx9.6 installed and connected with direct ethernet cable .. i need to review any steps available to do this task , the only one i found yet is for Stand-Alone cDAQ  9139 running Real Time mode not Win7 mode.

Best Regards

MyKat

[Tom_W_[DE]]

Hi MyKat-

We do not currently support remote connections between Windows host PCs and WES7 cDAQ-913x controllers.  As you noticed, this type of remote connection is possible with a LabVIEW RT-based cDAQ-913x controller.

Hopefully this helps-

[MyKat]

Hi Tom

please advice if NI might implement network with host pc feature for win7 embedded?

thanks

[Tom_W_[DE]]

Hi MyKat-

We have considered adding this support, but right now we do not have that feature committed for a future release.  I am interested to know why using this feature with a remote WES7 target is necessary (compared to remotely targeting a LabVIEW RT-based system) so that we can consider that feedback.

Thanks again for your interest-

[Tom_W_[DE]]

Hey MyKat-

I just noticed that this post is in the 'Measurement Studio for .NET Languages' forum, so I wanted to make sure my message was not misleading.  If we added a feature for remotely targeting WES7 cDAQ controllers, it would be a LabVIEW-based solution.  I do not expect either RT or WES7 systems to be remotely targetable from Measurement Studio/Visual Studio environments.  Apologies for any confusion.