Dear newsgroup,
We have a client that bought a NI 5102 for ISA oscilloscope. This client
needs to write a program to initialize, trig, wait for trig interrupt and
read the measurement. The oscilloscope is installed in a standard Pentium
200 MMX running Windows 95 with 64 Megs of ram.
The problem is that this program cannot be written from C for Windows or
from an instrumentation software like LabVIEW. For internal reasons, the
client is not interested in doing so. Therefore, the program will have to
be
written in C for DOS.
First, we would like to know where could we get a C program example.
Then we would like to find the document that describes all the registers
for
the NI 5102 oscilloscope so that we can read/write from the board. F
inally
to simplify our job we would like to know if there is a NI-DAQ for DOS that
supports the NI 5102 board.
-----------------------------------------
Steeve Allard
Software Designer/Concepteur de Logiciels
Averna Technologies
19 Le Royer Ouest, Suite 400
Montreal, Quebec
Canada
H2Y 1W4
Tel : 514-842-7577 ext: 205
Fax : 514-842-7573
Page : 514-720-7763
WWW : www.averna.ca
