In the instruction lab in which I work, we have two types of systems:1)SCXI-1000 chassis connected by copper to a PXI-6035E card in a PC.2)PXI-1010 chassis connected by fiberoptic from a MXI-3 to a PXI-6030E card in a PC. A PXI-6533 handles the digital I/O.We have LabVIEW8.5.1 running on both types of systems. On the SCXI-1000 system, the LabView example Acq&GraphVoltage-IntClk-DigStart.vi runs just fine. It does not run on the PXI-1010 systems. Instead, I eventually get Error-200284. In both cases we use PFI0 or PFI1, and digital ground, for the triggers, connected to lines 38, 39, and 33, respectively, in the SCXI-1302 terminal block, which connects to an SCXI-1180 feedthrough panel. I searched the forums and all ni.com for information on this problem, and have not been able to find any relevant information.Joseph D. Rudmin

Measurement Studio for VC++

Hi Jospeh,

That is correct. You will need to use a 68-68 pin connector cable to access the PFI lines on your PXI-6030E through your SCXI-1180.

S_Hong
National Instruments
Applications Engineer

Message 11 of 11

(3,288 Views)