Home Community Discussion Forums Most Active Hardware Boards Motion Control and Motor Drives Topic

Motion Control and Motor Drives

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Micro Controle IP28 - commands ?

Micro Controle IP28 - commands ?

‎01-24-2005 02:23 AM

Hi Everyone!

I'm an apprentice sat a company where we do measurings and was told to create a LabView-Programme, to controll a motor via GPIB. The Hardware I have to controll is pretty old. Its manufacured by Micro Controle (a French Company). The Hardware with the GPIB interface is a "Micro Controle IP28". The Problem is, there are no documentations or known commands to control it. Contacting the Manufacturer wasn't possible. So I was wondering if one of you guys know, where to get controll commands for the IP28? I hope that you can help me...

~Dennis

PS: Sorry for my bad english!
0 Kudos
Message 1 of 2
(3,508 Views)
Reply

Re: Micro Controle IP28 - commands ?

‎03-29-2005 06:37 AM

We have labview vi's for Micro Controle IP28 via the GPIB bus. Send me your email address to gert.hooft@philips.com and we will send you our vi's.
Message 2 of 2
(3,411 Views)
Reply