NI Motion Pack Controller, Error message: Configure Buffer -70137

[ste_phi]

Hello,

I am trying to operate a motion platform with an already supplied LabView software.

Unfortunately this software is not working properly and I get an error message. I also do not seem to be able to move the motors (I donot know if this is due to the error, or if this is another issue).

I modified the LabView code to output the error directly at the start (ErrorMonitor), and it gives me these Error messages:

What are these mentioned objects?

How can I proceed? What is the best way to troubleshoot? Is this a LabView problem or a problem with NI Motion/motors/cards/....?

(We use an NI Motion PCI-7340, everything was configured before I started to have a look at it).

I am new to this topic, and I will gladly add more information if you need anything else.

Thank you very much!! 🙂