Stepper motor control with NI9512 and cRio

[Nickdesse]

Hi,

For my thesis I would like to use a stepper motor to actuate a linear spindle. Therefore I ordered a stepper motor + spindle set from thomsonlinear (https://www.thomsonlinear.com/downloads/screws/Motorized_Lead_Screw_bruk.pdf) .

At my university I have a cRio platform at my disposal, so I wish to use this one. 

My question now is: What hardware components do I need to actuate my stepper motor in labview?

I found the following:

1) Ni9512 drive interface module

2) p70350 stepper motor drive

3) NI9512 to p7000 connectivity bundle

Is this correct and what other components do I need as well?

Best regards,

Nick

[Raz21]

Hello,

My question is, what do you need in order to run the stepper motor. Voltage? What voltage?

I need specific information about your stepper motor and setup. I cannot go through all those 30+ pag PDFs that you sent. 

Please post just the relevant information. 

Kind regards,

Razvan 

[Raz21]

Check this out: http://www.ni.com/white-paper/53027/en/