I am a new user in Labview and has minimal knowledge on this software. As a part of my project I need to control a Stepper motor using a phidget (Unipolar stepper motor controller). In my case what needs to happen is listed in the steps below
1) on selecting run the system is initialised and detection occurs to see if the phidget is attached
2) User on clicking a button open the stepper motor will turn a certain number of revelutions to open the barrier
3) Next on clicking close the barrier closes down i.e. the motor turns anticlockwise
I have used the phidget examples provided to study this and the value at which the barrier is closed is '0' and the value at which the barrier opens in '14000'
how can i set my switch to do this?
