hi,
I am new to labview and want to drive a 5 phase stepper motor using NI 7340 motion controller. I have third party stepper drive UMI 7774.The third party stepper drive has CW+,CW-,CCW+,CCW- terminals with which I have connected cw terminal of axis 1 control connector of UMI. I have connected both the motion controller terminal and digital i/o terminal to UMI 7774 respective terminals.I am attatching the steps I have taken to initialise the motion controller,But the motor is not moving.
Please tell me where is the error.
best regards
sumanta
