DAQ-6008 read value only at start

[Aljosa]

I have some problems with my first VI. A few days agou I bought new DAQ-6008 and started to use it. But in my firs VI, I did not have any problems with analog outputs, but I have it with analog inputs. In my VI, the DAQ-6008 reads right value on one of the analog input only at start up of VI. If I change the voltage on that input, nothing happened. When I stop and then start ti VI project again, I recive the right value, but then if I change the voltage..... nothnig.

What should I do?

[altenbach]

You'd probably get a better response posting in the LabVIEW or Multifunction DAQ forum.

This is not a technical board. It is for feedback on the forums.

Good luck! 🙂