Data Aquisition using ADVANTECH DAQ Card in LabVIEW

[Sankhadip]

I am using ADVANTECH DAQ card for data aquisition in LabVIEW. But the problem is I am able to get the signal in LabVIEW, which is visible only in waveform chart. I want to get in Waveform graph. How can I? It is actually a sinusoidal signal Plz Help .

[saeedsalehzade]

hi.

u must put it in a while loop. or use a collect signal in your block diagram

[Dennis_Knutson]

You've posted to the wrong board. This is for NI DAQ.

You also have not provided nearly enough information. If you are acquiring one point at a time, s chart of appropriate. A graph is used when you acquire multiple points at a time. Each depends on how you've actually configured the acquisition. I've never used your hardware so I don't know what is or is not possible with it.