Giving signal to AO as command signal to the controller

[Kirit]

My application labview is, using 2 Analog input signals (A & B) and subtracting (A-B) signal and using this signal as command line signal to Analog Output channel, which in-turn is connected to external relief valve controller which opens proportinally to the signal received at Analog Output channel.

I'm using PCI6259 & PCI6711 as hardware for my application.

I was checking for the same in examples, but couldn't get that.

Thanks in advance for the follow up

-Kirit

[Ujjval Shah]

Hi Kirit,

Search for the following examples in LabVIEW:

Input - Acq&Graph Voltage-Int Clk.vi

Output - Cont Gen Voltage Wfm-Int Clk.vi

Combine both the VIs into one and do the required modifications.

Hope this helps.

Regards,

Ujjval Shah

[Kirit]

Thanks Ujjval,

I have made that logic, even then i will look into the VI's suggested by you for any improvement that i can make on the logic i made....

Will get back to you after trying out

Thanks

Regards

Kirit