I have a torque cell going thru an in-line amplifier, then to a NI USB-6218 DAQ. There is also a prox sensor that goes directly to the DAQ. In Labview, once I start recording data, the prox signal shows up & reads in real-time, but the torque reading is delayed by ~20-30 seconds. Any reason why this would be?
The program used to show all data in real time, but just turned it on one day & it's now goofy. If I unplug the torque sensor, it still shows the delayed data for 20-30 sec before flat-lining.
Thanks.
