Hi all,
I want to pilote the motor controller (MDP First PAP 40/5) with the Multifunction DAQ6251 and I/O connector SCB-68.
So I use the AssistantDAQ in LabView to generate voltage with the output port ao0.
But when I initilize the AssistantDAQ block, there is always an error (see the following picture).
Meanwhile, I have the same error to configure DAG6251 in Measurement&Automation Explorer.
So how can I solve the problem? Is the card 6251 wrong or the software? I have reinstalled 6251 in computer.
Many Thanks,
Richwood
