USB-6211 Analog output won't go below 3.38V

[JaymeW]

Hi rfgarciar,

Is your board is failing the self calibration? If so, it more than likely needs to be sent in for repair.  

http://www.ni.com/support/

[hounddog]

I'm having a problem that is the opposite of yours: when I put a signal into the channels that are scaled by 2, MAX shows the table of data values 2X the input for a range of 0 - 10 VDC; however, when I look at the data going into the graph the values are always maxed out at 10.6 whenever I go over 5 VDC! And this is verified by the probe tool. Your are having a lower limit problem and I am having a higher limit problem. What gives?

[rfgarciar]

Oh! It is a new device. We bougth it one month ago.

[rfgarciar]

Hi JaymeW

Yes, is falling the selfcalibration 😞