calibration executive 2.1.1

[herbie]

Why are the channel numbers shown in the report, for say the calibration of a SCXI1102C, not consecutive?  ie the values shown may go to channel 14 for one gain then jump to channels 26 - 31 for another gain;  the the values for channels 15 - 31are found in another section of the table.

[JamesC]

Hi Herbie,

I don't have calibration executive installed, but have had this tested with with calibration executive 3.1.2 and the channels are recorded in the report in consecutive order.

You might be seeing an issue with Calibration Executive 2.1.1 that has not been documented as I could not find any record of the error you are seeing as being reported.

Sorry for this, but it looks like an issue that has been fixed in a later version, so a fix for 2.1.1 will not be issued.

Regards
JamesC
NIUK and Ireland

[herbie]

Thanks for that information.  This might help in my fight to get an update to Calibration Executive.

Cheers

Herbie