Automated Increasing Voltage is not output from the loop

[ShariqZahid]

Hi,
I have to provide increasing voltage (Linear/Logarithmic) into my test board. I created a program in LabView and while the output is visible on the waveform chart that is in the loop but there is no output voltage on the wire terminal. I have PXI4130 and PXI4110 on my PXIe1085 chassis. Is there a need to bring the output indicator out from the loop or it should provide the voltage on the pxi card?

When I take the output voltage indicator out of the loop, I only get the final value. I need rising voltage to be input in my test board at certain time intervals. 

[santo_13]

In your code, you're not using any NI DC Power drivers to control the Power Supplies or SMUs.

Quick primer,

• To control any hardware, you need to use it's driver functions
• To control PXI-4110 and PXI-4130, you need to use NI DC Power driver functions

[ShariqZahid]

Oh i am sorry.. I attached the wrong VI here is the one i was talking about.