After calibration PXI-5105 shows an error -201427 "The specified device is not supported within the NI-DAQmx API" on NI MAX
On SCOPE Soft Front Panel an error -239020 "Internal Hardware Error occurred in MIG hardware. Please contact National Instruments Support" is shown.
It worked perfectly before the yearly calibration. Tried reinstalling NI-DAQmx drivers, also downgrading and upgrading the NI-Scope drivers.
Tried inserting the scope into another chassis that's connected to another pc but the errors persist. Also tried inserting another scope to the chassis and the same slot and it worked fine.
Do you have any ideas?
