Adding working channels to the 9205 Basic I/O example project

[Judson]

Frankly I don't know why this is turning out to be so difficult.  It should be really really easy.  Here's the situation.

I'm moving my project into the format of the 9205 Basic I/O example project.  I'm doing this primarily to get the calibration done automatcially from the property nodes, etc... However I am unable to add channels to my project!!  I've made a few simple expansions as seen below.



What am I missing guys?  Could I get a quick walk-through or some serious direction?  These channels refuse to show up or output anything!!!

[stanthetiger]

Hi Judson,

To add channels to the project, you would

1) Right click on the Anlaog Input folder
2) Select New » FPGA I/O
3) Expand NI 9205 and select the channels you want to add.
4) Click the Add arrow and then click OK
5) The channels should be added to your project.

Regards,
Stanley Hu
National Instruments
Applications Engineering
http://www.ni.com/support