Create SSH or buffer before ADC

[Rsilva]

Hi ppl!

I would like to know if it's possible to create in labview an option to re-route AI to a buffer before sending the data to the ADC.

I will elaborate:

- Have 2 USB multifunction DAQs 6289;

- I know they don't support simultaneous sampling (unfortunately);

- I need to do 16 cycles of 28 measurements (simultaneous or very very close); 

So, since my hardware does not suppor Simultaneous Sample and Hold,  my question is:

Can I create a buffer or an SSH  similar system in LabVIEW?

The buffer should accept the 16x28 measurements before sending to the ADC (basically bypassing the ADC

until all the measurements are done).

Hope it's clear enough and someone can help.

P.S.: I'm using labview 8.6 and I cannot afford to buy new hardware since these Boards are new

Cheers!