Overload at DAQ causes unidentified error message

[Didi_0506]

During RT DAQ-process an overload condition (exceeding +/-10V) at the last (and only at the last!) channel causes my  vi to output the error: "Error 0 occurred at an unidentified location. Possible reason(s): LabVIEW: Error connecting to GPIB driver or device. NI-488: Error connecting to driver or device. VISA: (Hex 0x0) Operation completed successfully."

Has anybody a clue where to search for the error?

Hardware: PXIE-6358 X-Series DAQ, Controller PXIE-8108 Core 2 Duo

Software: LabVIEW 2010

[TobiasK]

Hi,

There could be a lot of reasons. I think it is better when you send your code. So we perhaps can debug it.

regards

Tobias

[Didi_0506]

Yes I see this also as the best way. In order to make it task easier, I will reduce the code to the necessary part and send it to the support. Thank you for the response anyway.