Hey together,
I've have a problem with my new cRIO system. I have the controller 9045 combined with a CanOpen modul 9881 and some AI-, AO- and DIO modules. The aim is to read/write analog data from/to sensors/actors, scale these data and write all scaled data to the CanBus using the 9881 modul. I have to run the 9881 in FPGA mode to transfer the data to the Bus. But I can't use the DAQ Assist in the FPGA Mode so I tried to create a seperate VI in RT mode and use the DAQ Assist in this VI.
My question are:
1. Did someone has done something similar?
2. How can I transfer the Data from the RT VI to thr FPGA VI?
3. Is this the right way or does someone has another way to do this?
Thanks guys
