Recording RPM in FlexLogger

[mhughes97]

I am looking to record a live RPM reading from a hydraulic motor using the Futek TRS 605 Torque sensor + single ended encoder 360ppr on FlexLogger - 9401.

I am able to calculate RPM after collecting the data, but I am struggling to set up a live reading. 

I understand what needs done to set up the calculation, I just lack the knowledge required set up the software to read the previous 1 second of pulse count data needed to read the RPM as a live output.

Any help would be greatly appreciated.

[ZYOng]

This question is best to be posted on the FlexLogger board

You can Configuring Calculated Channels