The embedded UI won't be loaded if I disconnect the video cable and connect again.

[biggershao]

HI NI friends,

After connecting cRIO to the monitor through the miniDP cable and entering the embedded UI, I disconnected the video cable and connected again，as a resut, the monitor had no signal. I hope you can tell me the reasons and solutions .

Looking forward to your reply!

[carmen9 · Accepted solution]

Hi,

http://www.ni.com/getting-started/set-up-hardware/compactrio/first-use

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P9EmSAK&l=en-US

[biggershao]

Thank you very much