Quarter bridge configuration 5B38

[Pat_Cas]

Hi there,

We seem to have some strain gage reading problems due to some wiring problems and we need to confirm the quarter bridge connections pins (4,3,1) using the 5B38 module. Attach is a picture depicting of how it should be set up. I like some confirmation if this setup is correct? Or is this setup incorrect? Thanks.

Sandy

[AnalogKid2DigitalMan]

Sandy

No picture was attached

[Pat_Cas]

Opps, here's the attachment I forgot to add.

Sandy

[Justin_M]

Sandy,

It looks like that wiring is correct.  Just make sure that the completion resistor matches the resistance of the strain guage.  So for example, if you have a 350 ohm strain guage, use a 350 ohm completion resistor.

-Justin