How to switch output parameters at run time

[Jacopo]

Hi,

I wrote a really simple LabView program to generate a square waveform with duty cycle changing at run time...

Anyway, to change the duty cycle it has to clear the task and then restart a new one with the new duty cycle: I don`t want it, cause during this time ( between the stop and the restart ) the output is obviously at zero!!!
I`d like to have a continuos sweep of the duty cycle in real time! 

Is it possible to have ?

Thank you really much!


Message Edited by Jacopo on 03-26-2008 09:47 AM

[AndreaN]

Hello Jacopo,

you can take a look at this document:

How Can I Change the Duty Cycle on My Continuous Pulse Train?

There is also an example attached at the document.

Hope this can solve your problem.

Regards,

Andrea N.

[Jacopo]

Thank you really much for the advise!

I read the article and I found the solution at my problem!