Signal express custom calibration data, where is it?

[mike_barrett]

I have a PXI 1042 rack with 4472 modules. I am using Signal exress 2011.

I have setup with custom scaling for the channels (so that I can log in engineering units rather than volts).

I have just replaced the disk and reinstalled everything. I have got everything working BUT...

When I try to open a previous Setup file it no comes up with an error stating it cant find the calibration values!

Is the custom scaling calibration data stored outside the Signal express setup file, if so where is it?

Thanks

mike

[mike_barrett]

Ok sorted.

Refitted old disc with previous system on it. Ran  Measurement and Explorer and then exported the configuration data.

Fitted new disk, imported configuratio data and all the scaling is restored.

Useful lesson, I had always thought the scaling was held in the TDMS files but its in the .nce files from the measurment and Explorer.

mike