Hi,
I am trying to send two Tx signals, derived from the same data file, and recieve both the incident and reflected waves of each Tx via a coupler. I have the Hardware set up as shown in my attached pictures and the block diagram for Rx(s) is also show along with how I am trying to write them to a TDMS file.
When I open the resulting TDMS file I get it some populated sets of data although these are repeated, so not what I was looking for.
I am simply wondering if this can actually be done, I have seen elsewhere people have been told that you cannot recieve on 'n' ports at the same time, but I am not sure if my situation is possibly different.
I am using an IQ rate of 1MHz to try and get it working initially so all signals should be below the threshold for my device to cope.
Thanks and all the best,
Daniel
