TCPIP Address in Labview Runtime

[mdali]

Hi, I'm not sure if I am posting this to the right place. Anyway I am an inter so please take it easy on me.

I made a VI that automates a test procedure using some agilent GPIB instruments and a leCroy scope hooked up through ethernet. On the computer i developed it on everything works perfectly i can pick all the instrument adresses no problem.

I built the executable and handed it off, now on a different computer using labview runtime engine the program can only find the GPIB adresses, not the TCPIP. any suggestions?

[margasan]

Hello mdali,

I think it might be a firewall issue, you may check this link: 

What Ports Do I Need to Open on My Firewall for National Instruments Software Products?

Regards

Mart G

[Herman_J.]

Hi.,

I am a LV user, but cannot open the referenced link...

Why ?

[AGJ_CR]

Hi Hermam,

I think that link is broken right now. Maybe the next one can provide you similar information:

Configuring Software and Hardware Firewalls to Support National Instruments Products:

http://www.ni.com/white-paper/12402/en/

Regards,

A Gomez