Hello, The last release of CompactRIO includes support for DAQmx on cRIO chassis (see What is CompactRIO with NI-DAQmx?). It is now possible to use some C series modules with DAQmx from any LabVIEW RT application in CompactRIO chassis. We can now access to C series modules unsing FPGA interface, Scan Mode or DAQmx (support may vary according to the considered module, see NI C Series Module Compatibility Chart). And what about VeriStand 2018 ? I did not find any information about that support in VeriStand 2018 What's New. So I made some test to use a NI 9203 with VeriStand using DAQmx interface, on a cRIO-9045. The module was properly configured in MAX to use DAQmx. VeriStand hardware discovery wasn't able to see the module. I tried to set it up manually, using the "Mod5" seen in MAX as device name, the project did not deploy: an error stands DAQ device not supported (or something like that). I know that VeriStand is build on LabVIEW, and this implies a kind of delay between new features available in LabVIEW and their implementation in native VeriStand features. Could you confirm that DAQmx interface for C series modules is not available in VeriStand 2018, using native DAQmx section in the System Explorer? Or is it supposed to work? (and what did I miss in configuration? ) Best regards,

Bonjour Mathieu, VeriStand 2018 officially supports all CompactRIO with NI-DAQmx controllers (cRIO-904x) as a RIO device. VeriStand 2018 does not yet support these controllers as a DAQmx device. Have a good day Best regards,

VeriStand

DAQmx Support for C series Modules on cRIO targets in VeriStand 2018

Solved!

Hello, I have the same question regarding Veristand 2023.

Message 11 of 11

(735 Views)

VeriStand

DAQmx Support for C series Modules on cRIO targets in VeriStand 2018

Re: DAQmx Support for C series Modules on cRIO targets in VeriStand 2018