Omega CN606TC2 with Dasylab 11

[suhardi]

s there someone who can help me

I connect CN606TC2 and Dasylab 11... using the RS232 cable, and have done the instruction manual of the book cn606tc2.
In dasylab RS232 module, there is a box:

1). Measurement data request,
2). Measurement data format ...

what should I write in the box is so modules dasylab Digital meters can be read from CN606TC2.

To start communication, the Command Module must send alert code ASCII [L] hex 4C. 

Commands requesting data from the scannerCN606TC2)

 ASCII [A] hex 41 = Zones/ Alarms/ Scan time

 ASCII [M] hex 4D = Model/ Password/ ID#/ # of zones

 ASCII [S] hex 53 = Setpoints

 ASCII [T] hex 54 = Temperature

I did not understand the program and the ASCII code.

I send [T] in the RS232 monitor and restore dasylab 54.
I am very grateful for your help

[Tim_O1]

You probably will have better luck getting a solution to this on different forums since these are not NI products. Below are some links that may help you.

Here is the user manual for CN606TC2

http://www.omega.com/Manuals/manualpdf/M2818.pdf

DASYLab

http://www.dasylab.com/

Good luck sorry I could not be more helpful

[suhardi]

thank you

[CJ_Butler__DASYLab_Pro]

Also, consider contacting Omega. They have access to both DASYLab and the hardware, and know how to reach me if they need my help. Without the hardware, I'm not sure if I can assist directly.