NI 6534 fails resource test.

[jsm 383]

The 6534 fails the 'resources test' under MAX.
Nothing is connected to the board. Board otherwise
seems to be producing NT crashes when used.

Any clues?

Thanks,

Scott

Details:
Error Message: The device is not responding to the
selected base address.
NI 6534 PCI form factor
Measurement Explorer 2.0.3.6
Windows NT V 4.0 SP 6
SBC is a ROBO-678 from Portwell.

[Filipe A.]

Hello;

This is pretty much looking like a hardware failure. One last test you can do before point the finger to the hardware is to do a fresh installation of NI-DAQ, on another machine (W98 or W2000 if possible), install the board and run MAX.
If the same behavior shows, the board is most likely bad, otherwise, you can try uninstall and reinstall the NI-DAQ driver on the machine which is presenting the problem.
Hope this helps.
Filipe A.
Applications Engineer
National Instruments