Read Binary File To LABVIEW Matrix

[057768022]

Hi Hal,

Thank you for your replay.

I have made the above modifications. I still can't write the data from the file.

I am getting the following error at the second "Write",

---------------------------------------------------------------------------------------------Error Remark------------------------------------------------------------------------------------------------------

Attempted to write a sample beyond the final sample generated. The generation has stopped, therefore the sample specified by the combination of position and offset will never be available.

Specify a position and offset which selects a sample up to, but not beyond, the final sample generated. The final sample generated can be determined by querying the total samples generated after a generation has stopped.

Attempted to Write Sample: 48

Property: RelativeTo
Corresponding Value: Current Write Position

I added my application. ( The sub vi's are in the previous post)

Best Regards,

Nir

[Hal_L]

Hi Nir,

I'm looking into your issue right now.  It may not be possible to trigger off of an 84khz clock in software. I apologize for saying that would work, but I did not originally think that your external clock would be at that high of a rate.  I will post another reply when I have more information.  Thank you for your patience on this issue.

Regards,

Hal L.

[mandar]

HI,
i'm using PCI 6534 Card .i want to read the serial data on the external clock
i have used DAQ MAX but i am unable to read from external clock as input to read serial data instead of that im using /Dev1/Dig0/SampleClockTimebase AS a clock source but i'm not sure that reads at it's +ve edge(rising)
since i want to use external clock source
please tell me how to proceed for this application

please reply me
mandar

(see attachment)

[Matt_A]

Hello mandar,

It appears that this issue is being discussed in another forum here. Please refer to that forum for more information.