Home Community Example Programs Example Code Document

Example Code

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
ASK A QUESTION

Using NI-SCOPE and Exporting Triggers

by: Active Participant
‎10-06-2008 09:16 AM
Last Edited by: Member Example_Scrubber_Guangwei ‎07-08-2017 03:48 AM

Products and Environment

This section reflects the products and operating system used to create the example.

To download NI software, including the products shown below, visit ni.com/downloads.

    Hardware

  • Modular Instrumentation

    Software

  • LabVIEW

    Driver

  • Other

Code and Documents

Attachment

Download All

Overview
This example uses the NI-SCOPE driver to perform a single configured acquisition off of a single channel.


Description
The acquisition will start on an analog edge and this start will cause a 5 V TTL trigger to be exported on a desired PFI/PXI Trigger/RTSI Line. The NI-SCOPE Export Trigger VI can be found under Measurement I/O»NI-SCOPE»Triggering»niScope Export Trigger.vi.


Requirements

  1. LabVIEW 2012 (or compatible)
  2. NI-SCOPE


Steps to Implement or Execute Code

  1. Compete device configuration, like Resource Name , Channel Name(s) and Trigger settings..
  2. Run the application

Additional Information or References
 VI Snippet

 NI-SCOPE EX Configured Acquisition (Exported Trigger) 2012 NIVerified.png

 

**This document has been updated to meet the current required format for the NI Code Exchange.**

Regards,
Dan King

Example code from the Example Code Exchange in the NI Community is licensed with the MIT license.

Comments
gurusj
Member
Member
on
‎11-08-2017 05:15 AM
‎11-08-2017 05:15 AM

Thanks a Lot for the Post...

0 Kudos