Can't reply to a post on LabVIEW forum

[moderator1983]

I tried replying to this post here, even I saw 'Succes' message and moreover I edited my post, but later I found that my rpely is missing and couldn't get published.

[RavensFan]

I had a different problem in the LabVIEW forum.  I tried to post this reply.  http://forums.ni.com/t5/LabVIEW/LabView-2012-Security-System-Main-vi-s-have-error-200559/m-p/2859192...

I had put a couple links in there reference a thread on the version conversion board.  I could not post.  It kept giving me an error saying to fix and error that was an "Invalid URL".  The URL was valid because when I copied and pasted into the address bar, it took me where I wanted it to.  But I could not post the message until I completely deleted the address.  Even editing the HTML to let it be text rather and a hyperlink, it was still giving me an error.  Last night and this morning.

EDIT:  But just now I was able to post this message with the link just fine.

Interesting note.  When I edited this message, there is a piece of text under the edit box that says "form.MessageEditor.mediaSnippet.exists.description"

[RavensFan]

I had a disappearing post today as well.  I know I posted it.  Because I remember seeing after another post (that was actually much more detailed than mine) that was posted just a minute before mine.

I read the thread later in the day, and my post didn't show in the thread anymore.  No harm, as the other person's post was much better.  But I don't know what happened.

[JordanG]

Hey guys,

I think I know the culprit. Lithium developed a new tool that's been helping us detect spam. This new tool "learns" with time and sometimes identifies posts as spam that are in fact not spam. I believe this is what happened in your case, moderator1983.

RavensFan,

Has your post showed up yet? If not, I will check the spam quarantine just to be sure it's not stuck in there. When searching for any content in the quarantine posted by you, I got no results. Please let me know if the post is still missing.

Jordan

[RavensFan]

I'm not sure.  I don't remember which message I was replying into anymore to be able to go and look.  I'm not too worried about it for that particular post.

[X.]

I can't even TYPE in the Post Comment box in the LabVIEW Exchange forum (but that might be due to me being flagged as the bad guy on the block, according to the above poster)...

[crossrulz]

---

@X. wrote:

I can't even TYPE in the Post Comment box in the LabVIEW Exchange forum (but that might be due to me being flagged as the bad guy on the block, according to the above poster)...

---

Niether can I.

[altenbach]

---

@crossrulz wrote:

---

@X. wrote:

I can't even TYPE in the Post Comment box in the LabVIEW Exchange forum (but that might be due to me being flagged as the bad guy on the block, according to the above poster)...

---

Niether can I.

---

It seems the recent forum update did not go over too well. 😮

[RavensFan]

I can type into the edit box on the Idea Exchange, but I don't see any of the icons on the toolbar.  It is just a blank, light gray line where the editor tools should be.

[wiebe@CARYA]

just posted this:http://forums.ni.com/t5/Feedback-on-NI-Discussion-Forums/can-t-fill-in-text-in-idea-exchange-quot-Po...before reading all through this thread.

I don't think it's a bad guy flag, since it works ok-ish in IE 7.