AT-GPIB/TNT board driver with linux kernel 2.2.16

[allysonwu]

I have installed AT-GPIB/TNT board to my linux computer. I downloaded the driver 0.5.1 from ni web site, installed with no problem.

First I used Window98 OS to test my hardware setup. My GPIB board is connect HP E3632A DC Power supply. I can use window version's ibic to run ibfind, ibdev, ibwrt, ibrd. Then I booted to linux, load the drive. But when I run ibwrt, give "EBUS" error. I used small test program to verify that I would get the same error. But I couldn't get it from Windows.

Where is my problem? inside the driver? or linux driver setup?

Thank you in advance
Allyson

[Ryan_M]

Version 0.6 of the BETA driver is available at:
http://www.ni.com/linux

See if this new release gives you better performance

Ryan Mosley