Having problems installing the driver software

[OSAS]

I am having problems installing the driver software for the AT-GPIB/TNT board,NI-488.2 version 3.0.Whenever I run the diagnostic as specified I get the foolowing error messages:

ibdiag test-Error reading NI-PNP.INI

ibtest test ;-unable to locate c;\Windows\GPIB.INI

gpibIinfo test ;-warning you do not have the GPIB.DLL driver file installed.

I tried installing the software several it stills give the same response.

I would appreciate if you  could assist me in overcoming this problem.

Thanks,

Osayi .U.

[Simran_K]

Hi Osayi,

Can you please tell me what version of NI-488.2 you are using? To find this information go to Measurement & Automation Explorer and expand My System » Software. Click on NI-488.2 and the driver information will appear on the right.

Thank you,

 

[OSAS]

The version is 3.0 of the 488.2 software.

Thanks,

Osayi U

[OSAS]

Hi,

The version of the software is 2.7.2,pls disregard the previous reply .

Thanks,

Osayi U

[Dennis_Knutson]

There's no such thing as version 3. Did you look at the link? Did you not read what version of the driver you need for that old card?

[Dennis_Knutson]

2.7.2 does not exist either. Where are you finding these numbers?

[OSAS]

The version is MS- DOS,sorry for the earlier wrong version.

[Simran_K]

Hi Osayi,

Sorry about the confusion. You need to download NI-488.2 version 2.7.2. Uninstall the old driver and reinstall version 2.7.2. Please make sure the device is not connected when installing the driver.

Thank you,