Home Community Discussion Forums Most Active Hardware Boards Instrument Control (GPIB, Serial, VISA, IVI) Topic

Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

I cannot see my PCI-GPIB in MAX

I cannot see my PCI-GPIB in MAX

‎11-05-2001 10:00 PM

On a Win2k, lv602, ni488 1.6, MAX 2.1, the ni488 installation returns an error on post-installation reboot, "procedure entry point _StopSpying@ 0 dynamic link library nispylog.dll not found". I ok ther error, the boot completes and then the gpib wizard tests the sw and hw all are OK. Then I go to MAX and there are no GPIB references in devices and interfaces to scan, nor any gipb to install under "Create New..".
Thanks
Jim
0 Kudos
Message 1 of 2
(3,255 Views)
Reply

Re: I cannot see my PCI-GPIB in MAX

‎11-05-2001 11:09 PM

I pulled all the cards, uninstalled all my sw, lv, nidaq, ieee488, put back lv 602, ieee488, and last nidaq 6.9.1 and it FINALLY picked up the PCI-GPIB card.
0 Kudos
Message 2 of 2
(3,255 Views)
Reply