Impedance Analysis with the Keysight E5061B Network Analyzer with Labview

[VenuGopal@57]

Hi everyone,

Hope you all doing well,

I need to configure and measure impedance in E5061B analyzer using labview, i have some scpi commands and .VBA file i dont know how to use them 

can anyone guide me how to measure impedace,Z-parameter

scpi parameter:http://ena.support.keysight.com/e5061b/manuals/webhelp/eng/programming/command_reference/command_fin...

Thanking you,

Regards,

Venugopal.

[Dennis_Knutson]

Use Help> Find Instrument Drivers. At http://www.ni.com/downloads/instrument-drivers/ you'll find links that explain what a driver is and how to use one.

[nyc_(is_out_of_here)]

---

@Dennis_Knutson wrote:
Use Help> Find Instrument Drivers. At http://www.ni.com/downloads/instrument-drivers/ you'll find links that explain what a driver is and how to use one.

---

American test engineering jobs going overseas by the boatload to India, and we have to help them figure it out?

[VenuGopal@57]

Dear sir,

I have already downloadded the drivers but i can't find a vi to measure impedance 

thanking you,

Regards,

VenuGopal

[VenuGopal@57]

Dear sir,

Test engineer jobs can you send me some details 

thanking you,

Venugopal

[Dennis_Knutson]

Have you run the example that comes with the driver?

[VenuGopal@57]

Yes i checked thew examples there is no vi provided for Z parameters

[Dennis_Knutson · Accepted solution]

Start with setting the instrument up manually and pay attention to the front panel settings of the instrument. You should be able to map those to SCPI functions. The driver can be searched for those functions. Make sure you ave Context Help turned on. If you don't find a driver function that does exactly what you need, you have the source code.