Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Showing results for 
Search instead for 
Did you mean: 

Luigs and Neumann SM1 Micromanupulator

Hi all,

 

Has anyone ever seen a driver or command set for a Luigs and Neumann SM 1 Micromanipulator? We do have portions of a legacy driver/utility.  But not enough to run or see all of the VIs.

 

Thanks for any info.

 

Dustin_D

Dustin D

0 Kudos
Message 1 of 4
(4,550 Views)

@Dustin_D wrote:
We do have portions of a legacy driver/utility.  But not enough to run or see all of the VIs.

 


 

Not sure what that means?

0 Kudos
Message 2 of 4
(4,545 Views)

It's only partially complete, somewhere along its life, there has been VIs removed.  It's hard to tell what is supposed to be there but judging by the architecture or lack thereof, It would be easier and more productive to reconstruct the driver from a command set; if we had one.

 

That is the less important part, we really don't have anything other than a box that we don't know how to communicate with so I'm really just trying to gauge if this information exists at all.

Dustin D

0 Kudos
Message 3 of 4
(4,543 Views)

Wouldn't the place to start be http://www.luigs-neumann.com

0 Kudos
Message 4 of 4
(4,536 Views)