I have been using NI-VISA for Packing Application (OS- Windows 7 -32 & 64) for last many years. Basically, it is used to send "Printing commands" to Zebra Printer via "Ni-VISA USB Address".
But in Windows 10 (32 & 64), we are unable to install same USB Printer by "NI-VISA Driver Wizard".
We tried some alternative way to install it but it is not getting detected in NI Interactive control. (as per attached link)
Message: Insufficient Location.
https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z0000019KvOSAU
Note:
Software: LabVIEW 17
NI Visa: 17
