Read data from a Fluke 289 multimeter using LabVIEW

[Fidelius]

Hi Widhi,

I checked your program in my computer and it ran good without problems. It runs in windows xp, probably you have hardware problem. 

[Fidelius]

I checked  your program fluke289.vi and ran good, I used labview 9 sp1 under windows xp.  Probably you have hardware problems.

Best Regards, 

[PartTimeLVUser]

Hello,

sorry for reactivating this old thread, but I still have a problem. Does anybody of you know, how to read the full log out of the Fluke 289 DMM? I would like to read the logged measurements, too, not just the current ones.

[nyc_(is_out_of_here)]

---

@PartTimeLVUser wrote:

Does anybody of you know, how to read the full log out of the Fluke 289 DMM? I would like to read the logged measurements, too, not just the current ones.

---

Try reading the programmer's or owner's manual for this instrument.

[PartTimeLVUser]

Try failed.

It's not mentioned in the manual. You should use FlukeView to download the logs, but I would like to do it with an own LabVIEW program.

[Dennis_Knutson]

Then you can use NI-Spy/NI-Trace to capture the undocumented commands.

[PartTimeLVUser]

...which is also not possible for me as I don't have the original Fluke software... 😞 (which is quite expensive)

[Dennis_Knutson]

If you dont have this Flukeview, then you need to talk to Fluke.

[nyc_(is_out_of_here)]

---

@PartTimeLVUser wrote:

...which is also not possible for me as I don't have the original Fluke software... 😞 (which is quite expensive)

---

Quite expensive????

$210 for FVF with cable is "expensive" ????

[PartTimeLVUser]

Yes if you don't need it and already own the cable. And if you already payed about 600€ to Fluke for the instrument and the cable.

So back to topic: is there anybody who knows the protokoll?