Currently I am trying to use the tkdpo7k driver set to control a Tektronix TDS6604 O-scope to read a series of waveform pulses that can occur between 500ms to 5s apart. What I am currently doing with an older scope is:
- Configure the scope (vertical horizontal acquisition mode trigger etc.)
- Tell the scope to acquire the waveform.
- Once the next waveform is acquired I process the information.
When I try using the equivilant plugins for the 6604 in my program I cannot get it to wait till a new waveform is acquired in fact I do not even have to have a waveform present it just runs straight through.
Any thought or suggestions will be helpful
James
