[USRP-RIO] Error -367000 in modified streaming example

[Nicola_TUD]

Hi,

we are using the following setup:

• A USRP-RIO is connected via PCI card to a desktop PC (transmitter)
• Another USRP-RIO is connected via PCI card to another desktop PC (receiver)
• A modified version of the stock streaming example is used to transmit and receive.
• The modifications are limited to waveform generation and display, i.e. 2 independent Tx channels and 2 independetnt Rx channels are employed
• LVC version 1.0.0.50009

Turning the transmitter on and off, every once in a while, this message would occur after pressing the "STOP" button. Between the different runs, I have been actually only changing some settings in the GUI. The behaviour was not reproducible in a deterministic way.

By now, the problem does not occur anymore. Not sure what was the actual solution.

Nicola

[MelanieE]

Hi Nikola,

since you do not know, which settings produced the issue, I can only guess what could have been the cause: The error usually indicates a trigger timeout. So if you use a trigger line but no trigger is received over a specified time, the error message is seen.

Best regards,

Melanie