Home Community User Groups Product Groups LabVIEW Interface for Arduino (LIFA) LabVIEW Interface for Arduino Discussions Topic

LabVIEW Interface for Arduino Discussions

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

mega2560 not working with Hobyist tool kit

mega2560 not working with Hobyist tool kit

‎06-26-2021 03:16 AM - edited ‎06-28-2021 12:25 PM

I have programmed my mega2560 with the firmware wizard and when running the example LV reports it cannot open the serial port.

I have selected the correct serial port (used by the mega). any ideas why this would happen appreciated.

 

 Note : I did the same with my UNO and the UNO board is working 100% both LED examples just fine proving the Hobbyist tool in LV is working and py process of programming the firmware on the Arduino is correct I assume there is a firmware issue with the mega2560

 

Thanks a million for helping out 

 

P1.jpgP2.jpgP3.jpg

---------------------------------------------------------------------------------------
Learning is an endless process but needs to start some where
0 Kudos
Message 1 of 1
(1,231 Views)
Reply