BAR Code QR Code Problem

[Zahkay]

hmm sir an example or tutorial would have help

if u dont mind.:)

[RavensFan]

---

@Zahkay wrote:

but what do u mean by the pseudocode

how the condition should be

since it is in labview. it should be in block diagram yeah..

pseudocode is not c coding

correct me if i am wrong.

---

Pseudocode

[Zahkay]

yeah sir

i did understand the pseudocode

but how to interface this in labview

is there any specfic way

[RavensFan]

I would recommend looking at the online LabVIEW tutorials
LabVIEW Introduction Course - Three Hours
LabVIEW Introduction Course - Six Hours

[Zahkay]

thank u very much for sharing these tutorials

but there is no  psuedocode in those tutorials which will help

to sove the issue of the vi i am doing..

[RavensFan]

Of course not.

Pseudocode is a short hand way to describe what you want the code to do.

The tutorials are to show you how to program in LabVIEW.

If you can't make the connection between the two to figure out how to program what you want to do, I suggest you go take a more basic programming course.

[Dennis_Knutson]

Have you even glanced at the Boolean palette? Aren't you running with the context help window open?

[Zahkay]

Hello dennis

yeah i do that. all the time when i have some problem, i check the help and

online resources

but for this issue, i dont have any clue about it.

[Zahkay]

Okie thank u for the advice sir

[alialiali]

Dar All,

Thank you all very much for your help. I have successfully completed this project. I put my results in AND operator, and when both the codes were acquired, then the data was written. Once again, thank you for the efforts.

Qasim