Bytronic Simulation Model Gauging Head advice

[D]

Hi all,

I've been using the Bytronic Simulation model over the last few weeks and
i'd like to get the gauging head to work.

I can manage to activate the clamping action on the gauging head since it
uses the same 40 way MPCT4 cable, and hence uses Port A bit 5. But i'm
having problems reading in from it, i've looked in the manual but cannot
seem to work out the base address for this operation.. where am i going
wrong?!

Note. The base address of the cards are set at default.

hope someone can help

[Dennis_Knutson]

Is there a LabVIEW question you have?

[Randy_H]

D,

I would suggest contacting Bytronic for this kind of information.

Randy Hoskin
Applications Engineer
National Instruments
http://www.ni.com/ask