Change the transition order in the state diagram

[Joseph_Loo]

I am running Labview 8.0.1 with the state diagram. In the previous version of Labview 7, I was able to change the order of transition state. In the current version, I do not see how to change the order of execution of the different transition state. If I have 3 transitions in a state, A, B, and Default that point to two states State-Default and State-A. Transition B points back to the same state. I want to check the requirements on Transition B before I go to the other transition test.

How do you change the transition execution order. I believe under Labview 7 all you do is change it in the state diagram. In the current version, there is no option on the change.

[devchander]

could you post the concerned VI?? and also tell in which order/condition you want transition to occur

[Joseph_Loo]

It could be pilot error, but all of the suddent the reorder transition menu has reappeared on the state diagram.

[Ben]

Thank you for the update Joseph!

I was scared for a second there.

Ben