06-14-2012 04:50 AM
Is it possible to add two-state contacts to Multisim and control them from LabVIEW in a boolean way?
attached example diagram
Solved! Go to Solution.
06-14-2012 02:18 PM - last edited on 02-10-2026 10:08 AM by Content Cleaner
There is as far as I know no possibility to manipulate with the interactive components from LabVIEW.
In case of your application couldn't you just use a transistor diode?
Something similar is done in this link:
https://forums.ni.com/t5/Example-Code/Complete-System-Simulation-of-a-3-Phase-Inverter-Using-NI/ta-p...
Best Regards
Anders Rohde
06-15-2012 03:49 AM - last edited on 02-10-2026 10:08 AM by Content Cleaner
Solved: https://forums.ni.com/t5/Multisim-and-Ultiboard/Co-Simulation-Multisim-LabVIEW/m-p/2032200#M12254
