Commande rohde und schwarz

[web_II]

Dear all,

i'm currently trying to write a VI with Labview to command a NWA Rohde und Schwarz ZVB.

I'm looking for the commands that should  be sent to the analysor via VISA that may set some parameters like F-start, F-stop, Number of points, etc.

For the analysors HP, there is a long list on the web site, containig all necessary commands and syntax to communicate withe the NWA via Labview, for Rohde und Schwarz, i searched but i did not find.

Can you help me please find these commands to solve my problem?

Thanks in advance

Best Regads

Message Edité par web_II le 10-02-2008 09:08 AM

[smercurio_fc]

In English:

 I go to write a VI with the aid of Labview to order a network sniffer Rohde und Schwarz ZVB.

What are the commands that I send to peus NWA with VISA to make actions such as: defining F-start, F-stop number of points, etc..
For analogue HP ago on the site a list of commands ... I looked at the site of R & S but I have not found it!

qq can help me solve this problem?

Thank you in advance

Have you downloaded the instrument drivers which you can find here:

http://sine.ni.com/apps/utf8/niid_web_display.download_page?p_id_guid=1002614A2E4A590FE0440003BA7CCD...

[web_II]

The link you sent me contains ready programs...it is good, but it's not mentioned what is avery "code" doing...

I need a list with all commands, to write myself my proper VI.

Thanks

[smercurio_fc]

The Rohde & Schwarz web site contains the full operating manual for the instrument:

http://www2.rohde-schwarz.com/en/products/test_and_measurement/product_categories/network_analysis/Z...

It's in the Downloads -> Manuals section. Do you have this?

[web_II · Accepted solution]

Oh thanks a lot for ur answer!

It was very helpful for me.